Scrapbooking

Love

May 20, 2020

Good morning! Laura here today to share another wedding layout I created for my beautiful nieces upcoming wedding!

To create this layout:
Step 1 – distress the edges of a 12×12 sheet of paper
Step 2 – trim one sheet of paper to 11.5 x 11.5 and distress the edges then adhere it t o the 12×12 sheet
Step 3 – trim a sheet of coordinating paper to 5×12 and cover both sides with clear gesso and allow to dry.
Step 4 – using the Make Your Mark Stencil – using the heart part of the stencil and texture paste – stencil it at the top of the 5×12 sheet of paper
Step 5 – using Fire Opal silk microfine glitter and black embossing powder and sprinkle both on the texture paste. Remove excess then heat set with your heat gun – repeat at the bottom of this page.

Step 6 – distress the edges then adhere to the previous pages in the center
Step 7 – die cut 2 large 1/2 hearts (making sure you have one die cut opposite to the first one so you can put them together to make one large heart) using the Planner Essentials 20 set
Step 8 – die cut two of the smaller size hearts also making sure to die cut one inverted so you can make one heart) from the same set. Distress the edges of all four pieces
Step 9 – adhere smaller heart to larger heart making sure to line up the holes.
Step 10 – using coordinating ribbon, lace the holes at the top (if you are using a smaller then 6×4 photo or if your photo is vertical rather then horizontal repeat this step at the bottom of the heart)
Step 11 – adhere the hearts to page then create a bow and adhere to the top of where you laced
Step 12 – cut a double photo mat for your photo and adhere

Step 12 – Die cut the title also from the planner essentials 20
Step 13 – die cut and assemble 5 flowers using your favorite ECD flower dies. Dip each petal in a little bit of glue then in the Fire Opal glitter. If desired add a pearl to the center of each flower.
Step 14 – Die cut two of heart Blooming Branches and using the red craft drops dot the flowers and hearts
Step 15 – adhere all those pieces

Step 16 – Die cut the a large and small heart dangel from the Planner Essential 25. Die cut it again if you did not use double sided paper so the heart is of different paper.

Step 17 – add gold Craft Drops, and beads around the layout

Thanks so much for stopping by!
~Laura

Elizabeth Craft Designs Supplies:

You Might Also Like

%d bloggers like this: