Elizabeth Craft Designs General Joset Designs

You Are Pandastic Card

June 30, 2020

Hi everyone, it’s Tina here. Panda’s are one of my favourite animals and I used the Panda Bear die to create today’s card. I used it along with the Bridge & Lotus and Adventure Edges Dies with the Bear Hugs Stamp set. Below you will find the steps to create your own You Are Pandastic card.

Step 1 – Trim White Soft Finish Cardstock to 8 1/2” x 5 1/2”, score at 4 1/2” and fold in half for a vertical side fold card. (A2)

Step 2 – Trim Light Green Cardstock to 5 1/2” x 4 1/2” and adhere to card front using 3mm Clear Double Sided Adhesive.

Step 3 – Stamp Bear Hugs sentiment using Versafine Onyx Black Ink to the center bottom of the card.

Step 4 – Diecut Adventure Edges (Clouds) x 2using White Soft Finish Cardstock. Ink up the edges using any ink of your choice. I used Distress Oxide Tumbled Glass. Adhere to the card front the bottom layer using 3mm Clear Double Sided Adhesive and the top layer using Foam Tape.

Step 5 – Diecut Bridge & Lotus in various colours of Cardstock. Assemble then adhere to card using Foam Tape for the everything except the Lotus and Leaves use Kid’s Choice Glue. A trick.

Step 6 – Diecut Panda using White and Black Cardstock. Assemble then adhere to card using Foam Tape. A tip: Place the images on your card and once you are happy with the design use Press ‘N Seal to pick up the pieces. Add the adhesive to the backside and then place on top of your card. Doing this step will ensure that your images will remain in the same place.

This can be used for many occasions by changing the sentiment. Below is a link to all the products used. Thank you for stopping by and Happy Crafting!

Products Used:

You Might Also Like

No Comments

Leave a Reply

%d bloggers like this: